Page 1 of 1
Infinite loop after recalc a trip.
Posted: Mon Jun 02, 2025 5:44 pm
by overlookh
I found that creating a trip with tread or with the xt2 the recalc is going in a infinite loop near 70-80%.
Rebooting the unit the first time is going well.
Any idea?
Re: Infinite loop after recalc a trip.
Posted: Thu Jun 05, 2025 12:09 pm
by finerone
I've seen similar behavior with recalc hanging around that 70–80% mark, especially when using tread or XT2. It seems like a loop that doesn’t resolve unless you force a reboot. Rebooting usually clears it temporarily, like you said, but it might point to a bug in the latest software version. It could be worth noting what firmware you’re on, just in case it’s tied to a specific update.
Re: Infinite loop after recalc a trip.
Posted: Fri Jun 06, 2025 6:37 pm
by overlookh
Happy to discovery i am not alone experiencing the loop.
I am using the last version of zumo XT2 firmware and the last tread.
In the last trip I was beginning to test the complete MRA system.
The interfac Is not so mature as zumo but more more more ... affordable.
Designing a route with tread or zumo Is like gambling.
Some time go, some time not.
