Page 1 of 1
Power button
Posted: Wed Aug 30, 2023 4:02 pm
by copycat73
Hi one and all ,
just a quick one ...the rubber power button on my 340 has fell to bits,
would any one know where i could buy a replacement ?..
tia.
Re: Power button
Posted: Wed Aug 30, 2023 8:52 pm
by MSTOCK27370
If you are in the USA, (N.A.?) send the device to PalmDr.com - Palm Doctor. They have repaired many of my Garmin GPS devices, screens, batteries, power buttons. Reasonable cost, and excellent work.
Re: Power button
Posted: Thu Aug 31, 2023 7:59 am
by copycat73
bit far as im in the uk.
Re: Power button
Posted: Sat Sep 16, 2023 6:49 pm
by copycat73
update.. i did contact PalmDr.com .. not so much as power button.... as a tablet
Re: Power button
Posted: Mon Sep 23, 2024 9:27 pm
by pepgra
I am a 3D printing enthusiast and have been able to design this for everyone.
https://makerworld.com/en/models/659875 ... eId-587018
a cordial greeting
Re: Power button
Posted: Tue Sep 24, 2024 10:18 am
by jfheath
If you still have the button, and it is the joining membrane that has disintegrated you can tape over the hole on the back, fit the button from the inside and glue it with some flexible glue. Eg uhu extreme repair. Careful not to get it on the back of the button - just down the sides. There will be enough movemnet onnet in the button to activate the micro switch on the circuit board.
Then remove the tape when it has set.