Handlebar Controller for XT2

[turbo19]

Playing, I have installed everything according to the scheme that was shared on the forum. Trying different options. The feel of the buttons is very good.

Allow me : !! John (moderator)

turbo19-1.jpg (279.14 KiB) Viewed 1344 times

turbo19-2.jpg (328.03 KiB) Viewed 1344 times

turbo19-3.jpg (295.38 KiB) Viewed 1344 times

[jfheath]

Thanks for posting those @turbo19 .

Please excuse me (ab)using my moderator privileges and copying the images to twist them through 90 deg).
It looks like a really good fit on your bars.

Mine will be here next week - but Its a surprise. It'll be an even bigger one when the cables come 5 weeks later. I'm not in a rush though. The entire fairing will have to come off to replace the wiring harness.

[Francis]

Maybe the Remote Controller needs a more restricted voltage of 10 to 12V than the varying voltage that is provided by a direct connection to the battery ?

Excellent point. Mine comes today and I'm going to use it.

Marc

For restrict voltage for remote controller, may be enough simple circuit with Zener diode?

[Francis]

It occurred to me ... can somebody to measure the voltage in Y-cable in micro-USB connector for the Remote control? Maybe there is only 5V in the cable from XT2 to remote controller, then the new power cable would be unnecessary.

[turbo19]

The problem I had was with the plug. I couldn't find a similar one. I didn't dare cut the Y cable (to put in another plug).

I have several electronic friends, and they have sent me plugs that are similar but never the same. Maybe some manufacturer makes them exclusively for Garmin.

If you find the male plug needed to feed the Y cable, please tell us what model and reference it is

[Francis]

... I didn't dare cut the Y cable (to put in another plug) ...

I'm lazy, I'll take the path of least resistance. I won't be afraid to cut it.